Studies of the distribution of thermal stresses in three-section brake pads of freight cars during movement

In this article, with the help of software, the relationship between the structure of the material of the brake pad and the temperature distribution of thermal stress on it is established. Spatio-temporal distributions of thermal stresses were analytically determined for the surface layer of the friction element based on the model of a three-section brake pad with non-fixed edges. At present, shoe brake is widely used for freight trains. It converts dynamic energy into thermal energy using the friction between the pads and the wheel, and then dissipates the thermal energy through a heat exchanger. This process includes heat transfer, design features, mechanical characteristics, material properties and other. The article pays special attention to the brake pad pressure, braking mode, brake pad material and other factors. Modeling of thermal effects is the most important in the design of vehicle parts and assemblies. Thermal research is an important step in the study of braking systems namely railway vehicles, where it is necessary to breakе large masses, since the thermal load on the braked railway wheel prevails compared to other types of loads. In this paper, the thermal stress on the friction element of the shoe during braking is investigated. In frictional braking, the process of friction between the brake pad and the wheel occurs at the points of actual contact. The heat flow from the points of actual contact spreads over the entire geometric area of the block.